About this deal
In the example above, although the command and the attribute have the same name "Power", they have different low-lever identifiers.
Zigbee Thermostat Radiator Valve, Smart Programmable Qiumi Zigbee Thermostat Radiator Valve, Smart Programmable
I want a pretty basic system, but I’m getting my head in a muddle trying to work out the automations required. He asked me about the impact of the radiator’s heat on the internal temperature sensor of the Moes ZigBee TRV I covered in my previous post. The offset will differ for each thermostat, as it’s influenced by the TRV location, radiator size and heat convection. RSL : RESULT = { "ZbState" :{ "Status" : 3 , "Message" : "Configured, starting coordinator" }} 19 : 08 : 46.
My solution for this is to have the set point a few degrees lower than the actual required temperature. What better presents the facts than a set of pretty charts displayed by Grafana and InfluxDB (if you fancy the same setup, I have a tutorial that guides you step by step to get that). NEST drops about 2% of the setpoints, so if your doing automated setpoints you’ll need to check and verify.
TRV is lying to you: TRV auto-calibration - NotEnoughTech Your TRV is lying to you: TRV auto-calibration - NotEnoughTech
As I happens, I had to factory reset one of the TRVs today because it had come undone as I had not screwed it onto the radiator tightly enough. When you create a new Zigbee network, it contains no devices except the coordinator (your Zigbee gateway).Your Nest thermostat controls whether the hot water flows to your radiator, and your radiator valve controls the pressure. I did not even try to pair with the Conbee2 / deConz as I knew I wanted to control everything via the Wiser Heat Hub.