About this deal
Plastic components are often fixed with the aid of adhesives to prevent them from slipping during further process handling. Acrylate-based adhesives in particular usually adhere very well to many plastics. They have a strengthening and supporting effect for load transfer and stress reduction. Acrylic adhesives, which are also used for permanent bonding, are characterised by short processing times and high strength to many plastics and elastomers. These adhesives achieve, for example, as 2-component adhesives on low-energy plastics such as PC, PMMA, PVC etc., good shear and peel strengths as well as good impact strength under dynamic loads. From the 3M Scotch-Weld series, even acrylic adhesives have been developed in the meantime, which provide good results on difficult to bond plastics with low surface energy without any surface preparation or primer. Bonding can be achieved by applying chemicals such as epoxies and plastic agents that bond by evaporation of a solvent or by curing a bonding agent with heat, pressure or time. ABS - acrylonitrile-butadiene-styrene is an everyday plastic that is widely used today because of its surface hardness, high impact strength and good resistance to weathering, ageing and chemicals. Unfortunately, the low-energy ABS cannot be glued completely without problems with common adhesives and usually this is only possible after a surface treatment with the solvent methyl isobutyl ketone. However, ABS with ABS can also be bonded with methyl ethyl ketone (MEK) / butanone and dichloromethane (methylene chloride). Optimum procedure: Clean bonding surfaces, dry. Apply one coat of adhesive to one or both sides and allow to flash off briefly before pressing together. Further information. The highly elastic silicone rubber (RTV/HE) is a quite flowable silicone rubber with very high elasticity and at the same time low viscosity. It is particularly suitable for the production of filigree elastic forms with pronounced undercuts. Fields of application are relief casting moulds or moulds for strongly structured decorative panels or wall elements.
product/helpAdviseTab.hbs -->