Joined in 2023 
82 
63 About this deal
Oxford are top of the list when it comes to aftermarket heated grips and their new Pro grips are their latest and greatest offering." Mad or Nomad Yes, as long as the bars measure 22mm and have not been changed from standard. They may require trimming tofit. Our supplier isn't able to provide us with an exact temperature, however have stated that if used on the maximum setting, which is only advised when the temperature is below 0 Celsius, you will notice a sufficient heat coming from the grips. Your bike has 1 inch diameter handlebars, so the only Hot grips that will fit are Oxford Cruiser Grips, which are designed specifically forcruisers. When it comes to working on bikes I wouldn't say I’m an amateur, but I'm not a professional – more someone who’s prepared to have a go.
As there are only the two wires fitted direct to the battery, I just needed six cable ties (four were supplied) to keep everything tidy. Having watched the YouTube video, the instructions made sense and were easy to follow. Would you choose your grips based on the length of your current factory fitted pair or maybe go a bitlonger/shorter? September 1, 2017 T he DataTool Therma Grips are unique in the fact that the controller is built into the left-hand grip. This saves the need to have to locate somewhere convenient to mount the controller. These grips, along with the Oxford Adventure grips, turn off when the ignition is switched off (if you wire any of the others directly to the battery they will always remain on, assuming the controller is on, regardless of whether the ignition is on or off ). This is a great benefit to stop flat batteries and it is far easier to connect directly to a battery than to wire into the ignition.I was a little surprised when I realised there were only three heat settings on the new grips, whereas the Oxford HotGrips Advanced model I used previously had nine. Having said that I haven't struggled with having only three settings – perhaps I had too much choice before. Hi, considering purchasing these as a gift for my husband. He has a Kawasaki zzr600. Will they be ok? Manythanks. December 1, 2017 When I fit heated grips I consider them a permanent fixture, but with care, they can be removed safely and easily, though this does, of course, depend on how much glue is applied. If your bars are 22mm, these grips will fit. If the bars are 1 inch, the only Oxford grips that will fit are the Cruisergrips. Intelligent heat setting memory - stores previous heat setting and defaults to this at power-up, saving time when in regular use. Note: Function is available when heat controller is connected to ignition.
The nicest grips on the test... HotGrips® Pro proved fast and accurate between settings with great comfort and grip." RiDE Recommended - Heated Grips Product TestAs long as the bars measure 22mm the grips will fit - you will need to find somewhere to mount the control unit. I have put the grips on my 125er and they hang over a bit on the end so I can get my balance bits bk on can I trim the ends down with put damaging the heating upprocess??? November 22, 2017 The ends of the grips will require cutting for anyone with hand guards as they only have a hole for bar ends. Leaving the end in place will result in them not fitting correctly and will hinder throttle movement. They are easy enough to cut through. Be aware not to cut into the heating elements as you will ruin the grips, something that’s not highlighted in the instructions.
Great Deal 
New Comment