Our fully trained technical team can support you with advice on setup, parts or repairs for electrical products. We also use cookies to analyse our traffic and share information about your use of our site with our analytics partners. mm diameter, in 26 and 60 mm lengths, the Termite Wall Chaser Rake, for angle grinders with M14 spindles, is suitable for use in aerated concrete - it is NOT suitable for use in traditional brick, block or concrete structures. A brief look (circa 2019) at Tungsten Mortar Rakes and the relative performance of three, four and six blade examples.

When coupled with a suitable dust extractor (vacuum unit) substantially dust free operation will be achieved and the waste debris will also be collected. For example, they mention it's a very good product, works really well and that it speeds up the pointing work. For a while now I’ve been using the diamond bits which are ok, but these are much better, the only thing you have to be mindful off is that when taking out soft bricks it does occasionally shoot off into the brick so not as much control as the diamond tips. The Irwin carbide tipped mortar rake cutters are ideal for the fast and efficient removal of mortar and cement joints in brickwork repointing applications and for chasing out channels for the installation of cable,pipes and switchboxes. Perfect for utilising an angle grinder to remove deteriorated mortar from between bricks in preparation for repointing.With exception of items listed below the Termite attachment will fit most Bosch, Hikoki (Hitachi), Makita, Metabo and DeWalt 115 mm or 125 mm angle grinders. uk/irwin-mortar-rakes-8mm-x-20-40mm-4-cutter-irw10507232 54467 IRWIN Mortar Rakes 8mm x 20/40mm 4 Cutter - IRW10507232 https://www. Nylon spacer rings compensate for the variations found across the range of compatible angle grinders. The Irwin carbide tipped mortar rake cutters are ideal for the fast and efficient removal of mortar and cement joints in brickwork repointing applications and for chasing out channels for the installation of cable, pipes and switchboxes.

Raking attachment combines dust and depth control functions with 'always open' extraction port and 'keyhole' extension for enhanced joint cleaning. They are also ideal for the short perp joints on brickwork, where a circular blade will not reach adequate depth due to the limitations imposed by the bricks above and below.For both depth and dust control, it is best used with the Termite Grinder Attachment - more details below.

Tungsten carbide mortar rakes are suitable for soft to medium strength mortar removal but will struggle with hard mortars, often encountered where poor quality repair work has previously been undertaken. Single motor SV30 M Class Dust Extractor with electric filter shaker, auto-sensing power tool socket and accessories kit. Trading Depot advises strongly against booking Tradesmen until after goods are safely received and checked for this exact reason. For deep cuts, it is probably best to make the initial cut with the standard 26 mm long rake and follow up with the same diameter of XL rake. If any of our products fall below the high standard you expect, we'll happily refund or exchange it within 14 days.A deeper joint might be required for inserting strengthening bars or to remove the mortar around a brick that needed removing (albeit a 60 mm rake is slightly short of a typical brick joint depth).