PRHTM - Infrared - Passive infrared activation with adjustable humidity setting and adjustable timer overrun Ensure that flexible duct connections are not over tightened to the spigots. To maximise the air flow, rigid ducting should be used where possible. The fan and ducting should be installed in accordance with the requirements of the Domestic Ventilation Compliance Guide, part of Part F of the Building Regulations. SAFETY FIRST: ALWAYS ISOLATE THE FAN UNIT FROM THE POWER SUPPLY BEFORE DOING ANY WORK ON THE FAN / MODULE.

Airflow Developments Ltd shall not be liable for any loss, injury or other consequential damage, in the event of a failure of the equipment or arising from, or in connection with, the equipment excepting only that nothing in this condition shall be construed as to exclude or restrict liability for negligence. Full details at airflow.com/terms iCONsmart has been CB tested and FCC certified to demonstrate the thoughtful engineering behind the fan design. It has been awarded the TUV certification for its safety, functionality and quality. Do not place the fan near any direct heat sources, e.g. radiant heaters, or where the ambient temperature can exceed 40°C (104°F).

Tangible Hydra-PEG Downloads

Model above is for basic on/off switching. Choose an optional control module to upgrade fan for Pull cord, Pull cord with adjustable timer, Humidity, pull cord with timer overrun, motion sensor with timer overrun, Motion sensor/humidity/timer . Don’t forget to add the control module you want. Only low voltage module fits low voltage fans. It/s so iCON easy Applications: iCONsmart has several features included as standard and can also be fitted with digital micro modules to give a range of extra control options. Standard Features Enter ICON – the new lens that provides a reassuringly simple and convenient solution to your RGP fitting needs.

All electrical installation must be carried out by an approved electrician in accordance with Part "P" U.K. Building Regulations and to the latest IET standards, or the appropriate regulations in the country of installation. When the iCONsmart is first powered on, you will hear the initial reset for 10-15 seconds. This is normal and will also occur if the fan is in its reset mode. App Control and Setup The iCON 15 is supplied for remote switching. Matching the required control functions (pull cord, timer, humidity, PIR, two speed) to the installation, simply means plugging in an interchangeable module into the iCON15 fan.The ICON15 comes complete with cantilever fixing lugs enabling a recessed installation on uneven surfaces. Easy to install due to the core drilled hole and its twist on/off cover enabling it to be fitted and fixed easily with its single side entry fixing screw.