To calculate the overall star rating and percentage breakdown by star, we don’t use a simple average. Phone MT AGENCIES in finglas and ask them for your nearest agent for the Aquasave bottom entry inlet valve low pressure. The Macdee dual flush valve is Water Regulations Advisory Scheme (WRAS) approved so you can rest assured of its quality and safety. the little leaver will probably be stuck in the down position, if so poke in to lift it back up, this will let the valve reset and the systen should fill up. Derwent Macdee offers an extensive choice of concealed and exposed cisterns with dual or single flush, siphons, and valves.

And when it comes to turning the whole body of the valve, I said anti-clockwise - but looking at your pictures it could be clockwise. The Kayla cable operated dual flush valve from Derwent Macdee is one of the number one sellers in the replacement market.I took off the cistern lid and poked around but couldn't make much sense of the workings - all the valves etc seem to be well hidden inside the plastic fittings and the way to remove them for inspection didn't seem obvious. PLEASE NOTE CERTAIN PARTS OF SCOTLAND, IRELAND and the ISLE of MAN will not be next day if chosen and will take an extra day. Thank you for your reply, that's a lot of company name changes in three years, the one I have is marked up 2008 when it was still Macdee! Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable). regarding fitting I assume I need to turn off the water - do I have to turn off the stopcock under the sink and then drain the attic tank (e.

Credit subject to status, UK residents only, Toolstation Ltd, acts as a broker and offers finance from a restricted range of finance providers, PayPal Credit is a trading name of PayPal UK Ltd, Whittaker House, Whittaker Avenue, Richmond-Upon-Thames, Surrey, United Kingdom, TW9 1EH. The unit is a Macdee AFV40100 flush valve - I can't see any markings on the inlet side, so I don't know who the manufacturer of that is - I assume the same. somhairle wrote:The cistern top simply lifts off but the attached hose prevents it from being set aside.A dual flush, cable operated Macdee Dump valve that can fit in existing Macdee brackets as well as fit cisterns with a 1. When I leave in the morning the cistern is at the max fill (6L) marker, however when I get home it's sat at the minimum marker (4. I will let everyone know how I go on, may be a useful guide for anyone with a similar problem in the future.

The cable-controlled flush valve can be easily fitted either to the top or the front of the cistern and is suitable for cisterns from 300 mm to 420 mm. I've had the same problem but I wasn't sure if it was the WD40 or whether the spring in the grey box behind the push button was the culprit. Unfortunately some moron has completely blocked in the back of the toilet (as it looks good, until something goes wrong.I give this 3 stars because I bought one in October 2019 (as the one that came installed with our bathroom about 5 years previously had broken - plunger mechanism was jamming so water was continually flushing into the bowl) but it has only lasted until August 2021 - with the same problem. what I find a bit odd is the fact that the plunger doesn't kick in to fill it back up as on the old "ball" cisterns the more the level dropped the more it would put back in. Although on my flush the smaller level indicator on the side of the unit was the trouble as it was sticking and preventing the plunger from going down far enough, you can ensure it is operating ok by making sure the that the bottom of the plunger is down a good 1 ins from the unit casing, if not it means the plunger is still sticking and the water will still run thru it into the toilet pan,so just make sure its 1 ins .

New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging .It wasn't clear to me if I could simply remove the top half of the old cistern valve, and replace it with this new one so I took the plunge (pun intended). Next job - try and figure out how these units can be disconnected from the cistern - can't see any obvious way to do it yet. Toilet flush valves are replacement parts for the toilet flush system, inside a toilet cistern that controls tank filling and toilet flushing. It can be put back in several positions, which allows you to adjust how tight the cable is when the button is pushed. The valve is suitable for retro-fit, new installations and high traffic areas and can be used with concealed, close coupled and low level cisterns.