By rejecting non-essential cookies, Reddit may still use certain cookies to ensure the proper functionality of our platform. Delamination of overcoat caused by application to near-full cured basecoat has NEVER occurred when the overcoat was applied within 7 days.

Unless protected with a treatment to kill enveloped coronaviruses, flu and bacteria, hand contact with doors, frames, window sills and other wood create a potential. It’s a great choice for interior surfaces that need a high level of protection such as work surfaces and areas of high wear, and it’s no wonder that it’s relied upon by decorators everywhere for a superior and long-lasting finish. A decorative and protective clear matt finish applied over Safewood systems and Thermoguard Fire Varnish Basecoat. The varnish is heat, water and scratch-resistant with long lasting protection against knocks, and most household chemicals in the home.

External, Damp or High Wear Applications: 2 coats Thermoguard Fire Varnish Overcoat (Exterior) Matt or Satin - Each 20m² pack is sufficient to apply 2 coats to 20m² of surface.

It doesn't smell, it's easy to apply, it gave a great finish with no skill from me, and it dried really fast. Finished beams spanning the length of your ceiling provide a beautiful accent to your home, but all that exposed wood can cause issues if a fire ignites in your home. Note, it mentions Mineral Spirits, if any solvent (except water) is added it is not considered food safe. Clean how you normally would and be sure to pay attention to any dirt or grit that could damage the surface. It can be brushed on ( check the instruction and follow those relating to safety - mainly good ventilation).Looking for confirmation it meets the 30min when applied to Victorian doors and would also like advise on the quantities required to achieve 30 protection and certification. We are required by building control to meet the requirements of Section 6 of approved Document B volume 2 with our wall lining meeting clarification C-s3, d2.

If you’re finishing smaller pieces like desk clocks and picture frames, they aren’t going to spread fire as quickly as structural elements and large sections of the facade, so you’ll probably be fine with either in these cases. Fire resistant paint gives hard, durable finishes suitable for timber beams, panelling, boarding, doors, floors and furniture etc. Each 20m2 pack of Thermoguard Fire Varnish Exterior Overcoat is sufficient to apply the required 2 coats to 20m2 of surface areaPlease note should you be unsure. Suitable for any bare or previously treated wood in the home including doors, furniture, shelving, skirting boards, cork, hardboard or chipboard. Envirograf Fire Retardant Enamel is an ideal choice for new and previously coated interior woodwork and complies with European Standard B/S1/d0 and British.Rawlins Paints sell a range of safety and security products, and it needs to be kept in mind that sources of arson or accidental fire can come from bins, storage facilities connected to a property, unkept foliage, and highly flammable materials left exposed to the sun or a heat source.

These clear or wood stain coloured translucent fireproof varnishes provide a fire protection layer allowing the ornate and decorative elements of wood to be kept as is, without having to use opaque, coloured coatings.Fiddes Table Top Polish is ideally suited for application on top of shellac sanding sealer, water based stains, Vandyke stain and Naptha Wood Stains. Precautions - Allow to dry thoroughly (up to 2 weeks for white spirit) Degrease with warm detergent solution necessary with some sanding required if a solid film has been formed. Please contact our technical support team if you are in doubt about a product’s coverage capacity to previously treated wood and timber surfaces. A clear varnish over exposed plywood sheathing board internally the the underside of a flat roof soffit of an extension.